Hold Up Time
Thanks to the good design, the hold-up time is long since the bulk cap is not that large compared to other high-capacity PSUs.
Inrush Current
The inrush current is on the high side with 115V and low with 230V. The same went down with the 1000W model.
Timings
The PSU supports Alternative Low Power Modes. The Power-on time (T1) should be below 100ms, ideally. Again, this was the case in the 1000W model.
Pages:
Why does it say 12VHPWR connector support but i cant see anyone on the pictures?
It uses 2x 8 pin on the modular panel for the 12VHPWR, which is safer.