Hold Up Time
The hold-up time is long, and the power ok signal is accurate.
Inrush Current
Inrush currents are high.
Timings
The PSU supports Alternative Low-Power Modes. For maximum mainboard compatibility, T1 should be below 100ms.
Pages:
The hold-up time is long, and the power ok signal is accurate.
Inrush currents are high.
The PSU supports Alternative Low-Power Modes. For maximum mainboard compatibility, T1 should be below 100ms.
My 9060XT 16GB graphics card has a typical board power (TBP) of 160W to 182W, which requires 13.3A to 15.2A of current. The card uses a 6+2 pin PCIe connector (600mm), but many power supplies use a mix of 16AWG and 18AWG wires for these connectors. Will the 18AWG wires be able to safely handle that much current?
3x gauges handle this current so it is ok.
please mate would you do a review Zalman Teramax II ATX 3.0 ?
will try to do so ok!
–“…and it managed to pass all tests”
Well, I see one red flag on the minor rail. If I’m counting it right, it’s just 0.42% out of 5% tolerance (5.42% under 3.3V)… or I miss something?