Lian Li EG1200G ATX v3.1 PSU Review

Efficiency Normal, Light & Super-Light Loads

Efficiency is high enough at normal loads at both voltage inputs but average at light loads. Lastly, it exceeds 70% with a 2% load.

Average Efficiency

The average efficiency is notably higher at 230V than at 115V.

Average PF

The APFC converter performs well.

Average Efficiency 5VSB

The 5VSB rail’s efficiency is high enough.

Vampire Power

Vampire power is low.

Pages ( 7 of 11 ): « Previous123456 7 891011Next »

Related Posts

15 thoughts on “Lian Li EG1200G ATX v3.1 PSU Review

  1. Just bought this one for a new build.

    The fan has a weird initial ramp up noise (grinding/bearing noise), then it quiets down 4-5 seconds after. Not sure if you had this issue while testing it. It can be a bit annoying since it’s 0RPM so you hear that ramp up motor/grind noise reasonable often even on idle.

    Here is a recording I did for reference which I posted on their Reddit page.

    https://www.reddit.com/r/lianli/comments/1mgbxg2/lian_li_1200w_edge_gold_fan_spin_up_noise/

      1. Got a replacement from Lian Li. The noise is still there but a bit better and lasts a shorter time. No obstructions.

        Its like an engine revv up noise for the first 3 seconds, then the noise goes away. Not sure if its just a bad fan curve going from zero to max rpm, or just a cheapo fan. Either way I might get something else with an Eco switch so i can just leave the fan on rather than getting ramp ups.

        1. Did some more digging, it looks like the Hong Hua fans are in some Seasonics and a few others. Apparently it doesn’t have a good reputation and now I know why. I actually found some testing you guys (Cybernetics) did on one of their fans and it rated it fairly well, so maybe it was just a bad batch?

          I’ve emailed their rep asking them to look at this internally.

  2. Just opted for this unit in preference to the 1200w Shift, largely due to the better cable quality and slightly better performance metrics. The shift uses Gen 5 cable connections. No mention of cable connections is mentioned in any review I’ve seen can I assume that these are gen 4 cables.

    1. Please note that Gen 4/5 cables refer to Corsair units. Unless you check, you should never mix cables between different brand PSUs, even between PSU models.

  3. Do we still need to concern about capacitor these days? Especially the japanese one? I read that Nippon-ChemiCon are now produced with Chinese Manufacture like ChengX that now make Rubycon and Nippon-ChemiCon. Does that mean they all now have the same quality?

Leave a Reply

Your email address will not be published. Required fields are marked *