Lian Li EG1000G ATX v3.1 PSU Review

Hold Up Time

The hold-up time exceeds 20ms, and the power ok signal is above 17ms.

Inrush Current

The inrush currents are low. I couldn’t get any readings at 115V, which is a good sign.

Timings

The PSU supports Alternative Low Power Modes.

Pages ( 6 of 11 ): « Previous12345 6 7891011Next »

Related Posts

7 thoughts on “Lian Li EG1000G ATX v3.1 PSU Review

  1. Respected Crmaris, what is your impression of HITACHI electrolytic capacitors? In your perspective, do you consider them to be in the same tier as NCC (Nippon Chemi-Con) and Rubycon?

  2. hello Aris based on your tier list which is better Unicon or Toshin Kogyo caps or it’s just on a same level ?

      1. so between TK LGW/LGWA/LGWB with TK LW/LFW/LFWB/LCW what’s different, i look at TK website there are no TK LW/LFW/LFWB/LCW on that product list but i’ve seen some cheap power supply with japan capacitor gimmick use these caps, so do they had real lifetime performance similar to LGW/LGWA/LGWB product or similar to other chinese caps like LTEC or ChengX ?

    1. Hi, I was wondering if you could answer some questions that I have concerns about. I recently purchased this psu Lian Li Edge 1000w gold and installed it in my rig to power an rtx 5080.
      With all these issues of 12vhpwr cables melting, I decided to check my 12v core voltages on hwinfo and noticed that this psu is showing readings of about 11.8v for PCIe and 16-pin, and would dip to as low as 11.6v under load.
      I’ve tried checking all the cables and made sure they’re seated properly to avail.
      Am I being too paranoid or do these reading look abnormally low. Should I submit and RMA and return the product?

Leave a Reply

Your email address will not be published. Required fields are marked *