Montech Titan PLA 1200W ATX v3.1 PSU Review

Hold Up Time

The hold-up time is long, and the power ok signal is accurate. It’s all good here.

Inrush Current

The inrush currents are high, especially at 230V.

Timings

The PSU supports Alternative Low Power Modes.

Pages ( 6 of 11 ): « Previous12345 6 7891011Next »

Related Posts

10 thoughts on “Montech Titan PLA 1200W ATX v3.1 PSU Review

  1. Would you consider reviewing some of the sama psus like black diamond, black hole, XP, and even the new upcoming GT series? When they’re in stock they’re at incredible prices, and my buddy who’s working on a psu database says some of their electrical performance is debatably a tier.

  2. Are there any notable safety concerns when using this as compared to a better reviewed 1200W-1300W PSU with a MSI RTX 5090 SUPRIM SOC?

    I already purchased this PSU (felt it was good as it is a Seasonic OEM and there are also very few white PSUs at >1200W)

    However I am now concerned after reading the cons listed in this review, and might switch to the [ASRock Taichi TC-1300T] or [Lian Li Edge Gold/Plat 1200W/1300W] if it would improve safety levels

    1. Look at the protection features table, everything you need to know is on this page.

      I liked the Taichi units, FSP is trying hard to make them highly competitive.

Leave a Reply

Your email address will not be published. Required fields are marked *